You are watching: 2010 honda odyssey power sliding door problem
How do you reset the doors on a Honda Odyssey?Sometimes the doors of an Odyssey refuse to cooperate and need a manual override to help restore their functions. It would be helpful to know the manual override procedure; you never know when your doors will refuse to open or close.
Honda Odyssey sliding door manual overrideThe following is a step-by-step procedure on how to override the sliding doors of a Honda Odyssey manually.1. Make sure that the main door switch is in the OFF position. Remove each of the following fuses one at a time and allow it to remain that way for at least 30 seconds:Driver’s side fuse box (Fuse no. 7 (7.5A)Passenger’s Side Fuse box (Fuse no. 7 (7.5A)The Primary Fuse box (Fuse no. 7 (7.5A)The Primary fuse box (Fuse no. 15 (40A) 2. Reinstall all the fuses in their original locations. Check to see that the primary switch for the doors is in the OFF position and that the ignition button is in the LOCK “0” position.3. Manually open both sliding doors fully.4. Turn the ignition button to the “II” position when both doors are fully open.5. On the dashboard, turn on the main switch for power sliding doors.6. Until the door is fully closed, press and hold the close side of the “Master Power door” button (switch for L & R doors under the main power switch on the dashboard). Repeat the procedure for the other slide door.7. You’re all set now. Use the switch, handle, and remote to open and close both doors for a test run.
Common Problems With the Honda Odyssey Doors and How to Fix ThemMost of the problems you may come across with the Honda Odyssey door can be remedied easily. Below are the common issues and step by step guides on how to fix them:
Honda Odyssey sliding door won’t open all the wayIf none of the above-mentioned methods work, use a manual reset. It would help if you first detached the vehicle’s battery. After that, close the doors. Replace the negative battery terminal first, then the positive one. The battery will reset as a result of this action.Turn your Odyssey on from the driver’s seat. Then, for a moment, locate the toggle switch and make sure it is off. Then you can return it back in place, the similar button that we discussed earlier near the steering wheel column.Now look for the power sliding door buttons, which should be two in total. As the Odyssey’s doors open, press down on these and hold the pressure. If the doors do not move, you must reset the switch and try again. From that point forward, the doors should fully open.
Honda Odyssey sliding door is beepingThe sliding door is beeping because your car is not fully closed, or the car sensors read it as so. You need first to switch your sliding door to the manual and to do this. You’ll need to turn off the power supply by switching off the power using the rear door buttons. The noise will stop as a result of this. Then, at the top back corner of the door opening, there’s a black rubber bumper. This rubber bumper is in place to keep the door from slamming into the metal edge if you manually open it too quickly.When the door opens automatically, it comes to a halt before touching the back edge of the aperture; make sure it is not loose. A loose rubber patch will register as a not fully closed door making the beeper go off, and you may need to get new rubber parts for your door.
Honda Odyssey sliding door has no powerWhile the power sliding door is functioning, if the battery terminal is disconnected or the No. B16 (10 A) fuse normally in the under-hood fuse/relay box detaches; the power sliding door will not open or close automatically until it resets. Here are steps of resetting the power door:Remove the No. B16 (10 A) fuse from the under-hood fuse/relay box to clear the power sliding door DTCs.Deactivate the door’s main switch. Ensure that the ignition switch sets to LOCK (0).Close the motorized sliding door entirely by hand (the control unit must see the complete latch switch closed and the ratchet switches open simultaneously).Turn the ignition button to the ON position (II). Activate the Main switch.Check the power sliding door switch, remote transmitter, and door handles for proper operation.
Honda Odyssey sliding door not fully closingThe Honda Odyssey is a dependable car that comprises sliding doors. A door may fail if it is in the wrong position or a piece of rubber has fallen off.Carefully place the rubber piece in its place and make sure the door is in the correct position; this would fix your door.
Honda Odyssey driver door won’t close.Disassemble the inner handle and remove the screw behind it:Pop off the little plastic cap.Slide the plastic slide ahead and then pull it off.Disconnect the electric door lock switch to remove it entirely.The cable connects to the other end of the door handle. It features a plastic insert, which serves to keep this wire in place. Based on your explanation, it appears the wire must have come out of this hole.
The Sliding Door Closes Then OpensAnother issue that may be afflicting your Odyssey is that the door closes entirely and then reopens. It’s never by much, perhaps a quarter of an inch or more.Even yet, you’re not comfortable leaving your door unlocked in this state, as it is technically open, and anyone can enter. Your entry may continue to beep, and depending on the model of your Honda Odyssey. Your dashboard may also display the “door open” light.To begin, turn off the master switch on the dashboard. Following that, you’ll want to open all of your doors manually. First, examine the door pillars and contacts and clean them with rubbing alcohol.Examine the door button on the back, made of rubber. If any of them are misplaced, reposition them. You may even need to replace the rubber components. Now is the time to activate the master switch, leaving the door slightly ajar.With the dashboard closing switch engaged, check to see if the door remains closed. If not, the problem may be the result of a blown fuse, in which case you should consult a car mechanic.
The Sliding Door of my Honda will not close All The WayIt would help if you first detached the vehicle’s battery. Then close the doors. Reconnect the negative battery terminal first, then follow with the positive, which effectively resets the battery.Turn on your Odyssey from the driver’s side. Locate the toggle switch and turn it off for a brief moment. Then you can re-energize it by pushing it. This switch is the same one nearing the steering wheel column that we discussed previously.Now locate the power sliding door buttons, which should be two in total. Apply pressure to these and maintain it when the Odyssey’s doors close. The doors may remain immobile, in which case you must reset the switch and attempt again. From that point forward, the doors should close completely.
The driver’s door on my Honda Odyssey won’t closeIf the driver door is not closing, follow the steps below to resolve the issue:Using the dashboard switch, turn off the power doors.Open the doors as far as they’ll go, but be gentleOptional: Wait 30 seconds before replacing fuse #13 in the passenger side fuse panel.Re-engage the power door switches on the dashboard.Close the doors using the dashboard or key fob. Use the door handle to test if the door is closed.
The Manual Sliding Door Won’t LatchThere are two possible causes: the fuse needs to be reset, the sensors need cleaning, or you have a dysfunctional rear latch. Both are things that your mechanic can handle.In your passenger fuse box, look for the 13th fuse. The fuse should be the fourth fuse on the top row. The fuse may say “clock reset,” but that depends on the Odyssey model. The fuse is reset by disconnecting it for around 30 seconds and then reinserting it.On the other hand, sensors are on your Odyssey’s door and body, depending on the model.Some Odyssey owners complained that they couldn’t get their latch to operate even after cleaning the sensors but that a mechanic could. So that’s something to think about as you move forward.
The Door Latch Is StuckAnother problem with your Odyssey’s door latch is that the latch itself is stuck! A screwdriver can help you open a locked latch, but replacing the closing motor unit is far preferable.Therefore, a motor and a new lock should be with this component. It’s also possible that a trip to the mechanic is in order.
See more: Brilliant Event Fantastic Flora And Fauna, Brilliant Event: Fantastic Flora And Fauna